SiT9367

SiT9367低抖动差分晶振在实际运行条件下具有出色的动态性能

• ● 0.23 ps抖动（典型值）
• ● ±10 ppm
• ● 在恶劣环境中具有更好的系统性能

• ● 最大程度减少高振动环境中的数据包丢失

• ● 简化电源设计

• ● 实现具有严格抖动要求的小型系统

• ● 220MHz - 725MHz任意频率，可精确到小数点后6位
• ● 2.5V - 3.3 V工作电压
• ● LVPECL，LVDS，HCSL：定制的振荡器规格，以实现最佳系统性能

• ● 10亿小时的平均无故障工作时间
• ● 终身保修
• ● 减少由于时钟组件和相关维修成本引起的现场故障

功能引脚示意图	脚位	功能		说明
	1	OE	Output Enable	H[6]: specified frequency output  L: output is high impedance
		ST	No Connect	H or L or Open: No effect on output frequency or other device functions.
	2	NC	NA	No Connect; Leave it floating or connect to GND for better heat dissipation
	3	GND	Power	VDD Power Supply Ground
	4	OUT+	Output	Oscillator output
	5	OUT-	Output	Complementary oscillator output
	6	VDD	Power	Power supply voltage[7]

Notes:
6. In OE mode, a pull-up resistor of 10 kΩ or less is recommended if pin 1 is not externally driven.
7. A capacitor of value 0.1 μF or higher between VDD and GND is required. An additional 10 μF capacitor between VDD and GND is required for the best phase jitter performance.